I think I paid $60 and waited a day for three aluminum pieces to be welded in some way. Two of which were water tight. Not bad.

 

not too bad, all the wielders i know around my area suck. maybe a 45 min drive to a good one. the reason im thinking of drilling and taping the ebay intercooler.

 

hey josh do you happen to remember which wire is the stock o2 sensor on the factory wiring. im working on wiring in the wideband.

 

ran into a huge issue, my mac laptop isnt seeing the usb/serial adapter.

 

i have seen the tune that was installed on the ms, and looked around at its inner workings a bit. is the coolant temperature accurate? but it seems i received a faulty wide band gauge, how do you test and make sure the sensor and controller are working correctly.

 

hey brain i got a predicament. most of the links to basemaps from your writeup are dead. this link to be more specific.
http://www.megasquirtpnp.com/downloa...tup_021108.exe

 

sounds like you have an MSI? for the AIT and CLT temp, the correct scaling must be flashed into the firmware. 99% of the time the correct GM AIT and MAzda CLT sensor is loaded.

But you need three correct .inc files to load into your project folder in order to correctly display the temps on your laptop.

As for the WBO2, the correct input device must be selected and you need to make sure the MS isn't set for NB mode.

http://www.boostedmiata.com/MS/msq/1...lone_noafm.zip

this has the .inc files and an msq. Please take in mind I haven't touched a MSI in over 3 years...

 

so those files go into the project folder, nothing special after that. i figured out the wbo2 though.

 

into the INC folder within the project folder.

 

brain quick vaccum source question. is the automatic trans fitting a good source for the ms