1.6l t3 60 dyno
07-31-2011 | 07:09 PM
#1
Thread Starter
MFz Lurker
Joined: Jul 2011
Posts: 28
From: Albany, GA
1.6l t3 60 dyno
Figured I'd post my first dyno atleast
By techsalvager at 2011-04-23
T3 60
7psi wastegate but it was going down to 4-5 psi and coming back in at 6psi~
still after some tuning, learning, and better understanding I was able to get 148whp on the dyno out of it.
Pretty sure now with all my leaks fixed If I were to dyno at a bar of boost I'd be around 210 or more
so far I've tuned in 150\175\200 map regions for fueling, I figure 225 is next and I"m ifft on going anymore past that to 250 on the stock bottom end.
By techsalvager at 2011-04-23
T3 60
7psi wastegate but it was going down to 4-5 psi and coming back in at 6psi~
still after some tuning, learning, and better understanding I was able to get 148whp on the dyno out of it.
Pretty sure now with all my leaks fixed If I were to dyno at a bar of boost I'd be around 210 or more
so far I've tuned in 150\175\200 map regions for fueling, I figure 225 is next and I"m ifft on going anymore past that to 250 on the stock bottom end.
Last edited by Hentai; 07-31-2011 at 07:20 PM.
07-31-2011 | 07:19 PM
#5
Thread Starter
MFz Lurker
Joined: Jul 2011
Posts: 28
From: Albany, GA
haha no, just went super rich up top again on that last area.
plus the AFR on the dyno sniffer was a point higher nearly compared to mine which I tuned off of. Just used the dyno sniffer to check overall curves match up.
I was able to do many pulls and learn how to use a dyno.
plus the AFR on the dyno sniffer was a point higher nearly compared to mine which I tuned off of. Just used the dyno sniffer to check overall curves match up.
I was able to do many pulls and learn how to use a dyno.
Last edited by Hentai; 07-31-2011 at 07:22 PM.
Thread
Thread Starter
Forum
Replies
Last Post
flying_solo
NB (1998-2005)
23
01-09-2012 12:14 PM